Fan Remote Control Not Working

Try using the remote to turn on the.

Fan remote control not working.

There s a lot of remotes out there that won t work with older fans. When to buy a new ceiling fan. If the remote does not work it may be an issue with the fan itself. This tells you that the fan remote control is sending a signal to the fan receiver.

If the fan won t turn on and the lights are working then there is power to the fan. The next possible reason why the fan is not working is to consider the remote. In this case replace the reverse switch. Check the reversing switch.

If you are using a remote or. If the working remote does not work with the ceiling fan receiver your ceiling fan receiver is broken and it is possible your ceiling fan remote is still working. They need to be set the same way on both the fan and the remote. If you ve replaced the remote checked the dipswitches and still cannot get the fan to work with the remote it may be time to purchase a new receiver unit.

If the remote is sending a signal check to see if the fan and the remote are set to the same frequencies. First ensure that the mains power is turned on and then check to ensure that the circuit breaker for the unit is not. Below are troubleshooting steps to follow. Check to ensure that the problem is not with the remote see fanimation remote not working guide above if the mains supply circuit.

Flip the switch several times to make sure it is the right. If fresh batteries and altering the settings on your fan receiver and remote did not work you may have a damaged remote control. When a button is pushed on the remote a red led light should light up. If this is happening then the battery is ok and the ceiling fan remote is functioning in a proper way.

Confirm the reverse switch is not in a neutral position. Follow the steps below to determine the cause. At this point you probably want the fan to be looked at setup professionally because it must be an issue with the receiver in the fan need a replacement remote. If you have an older ceiling fan the switch may be worn out.

This can usually be done by checking the dip switches. Make sure that the power is turned on to the fan. In terms of troubleshooting hunter ceiling fan remote controls much of the troubleshooting will be similar to troubleshooting other fans.