Faucet Shut Off Valve Replacement

Turn off the breaker to the water heater found the circuit breaker panel.

Faucet shut off valve replacement.

Then open a faucet on the lowest level of your house and another faucet on an upper level to drain the pipes. Step 1 turn off the main water valve. Prepare for valve replacement. Let the water flow through the faucet to clear air in the lines and check for leaks by feeling the fittings and.

Turn on the main water supply and open the supply valves. Under sink shutoff valves also called fixture shutoffs or stop valves allow you to turn off the water to the sink or other fixture without having to use the home s main shutoff. It is located in between the meter of your water and the house itself. If this happens to you you can simply replace the valve with a new valve that matches the old one.

Step 2 get rid of excess water. With a few household tool. These inexpensive little valves rarely get used and when they do sometimes they leak. Reassemble the shutoff valve turn the main house valve back on and check for leaks.

Required tools for this project have the necessary tools for this diy project lined up before you start you ll save time and frustration. Shut off the circuit breakers to an electric water heater. Ask this old house plumbing and heating expert richard trethewey helps a homeowner replace the shutoff valve underneath her kitchen sink. The angle stop valve is used where the water pipe enters the room to allow for easy shut off of water flow to the end fixture allowing for maintenance and repair without having to turn water off to the entire home.

Shut off the water at the main shutoff valve. Replacing a shut off valve compression valve or angle stop may seem like a daunting task but it really takes less than 5 minutes. If you have a gas water heater turn the knob to the pilot position. Tighten as necessary until the joints are sealed.

Shut down the main water valve connected to your house. If the valve leak persists turn off the main water shutoff valve then disconnect the valve and replace it.